Star Micronics LC24-10 User Manual page 79

Perform one n/180-inch or n/276-inch line feed
Mode ASCII Decimal
Hexadecimal
Both 1 < ESC > "J" n I27 74
n
IIB 4A
n
Feeds the paper once by n/180 inches (Standard mode) or n/216 inches
(IBM mode), where
n
is between 0 and 255. Does not move the print
position right or left when DIP switch l-2 is OFF; returns the carriage
to the left margin if DIP switch l-2 is ON. Does not change the
line-spacing setting.
Perform one nl7804nch reverse line feed
Mode
ASCII Decimal Hexadecimal
Std.
< ESC >
"j"
n
27 106 n
IB6A
n
Feeds the paper once by n/180 inches in the reverse direction. where n
is between 0 and 255. Does not move the print position right or left when
DIP switch l-2 is OFF; returns the carriage to the left margin if DIP switch
l-2 is ON. Does not change the line-spacing setting. Ignored when friction
feed is used.
Feed paper
n
lines
Mode ASCII
Decimal Hexadecimal
'ESC>
"f' "1"
n
27 102 49
n
IB 66 31
n
Both
<ESC>
"f
<I> n
27 102 1 n 1B 66 01
n
Feeds the paper n lines from the current line, where
n
is between 0 and
127.
Set top of page at current position
Mode ASCII Decimal
Hexadecimal
IBM <ESC>
"4"
27 52
IB 34
Sets the current position as the top-of-page position. Note that this can
also be done from the control panel.
Set page length to R lines
IModel ASCII
I
Decimal
I
Hexadecimal I
Both
<ESC> "C"
n
27 67 n 1B 43
n
Sets the page length to n lines in the current line spacing, where n is between
1 and 127 in Standard mode or between 1 and 255 in IBM mode. Changing
the line spacing later does not alter the physical page length. The current
line becomes the top of the page.