Removing The Roll Paper - Star Micronics 347F User Manual

Lower
paper
Upper paper
Fig. 2-12 Insertion of the paper into the auto cutter
Auto cutter
Fig. 2-13 Paper outlet of the front cover
(SP347)

2-3. Removing the Roll Paper

Remove the rear cover then cut off the paper near the rear of the paper guide. Then
press the "FEED" switch to feed out the rest of the paper that is remaining in the
unit.
When the paper runs out, a buzzer will sound four times per cycle for two cycles.
NOTE 1. Press the "FEED" switch to remove the rest of the paper that is in
the printer. (If you remove the paper by hand, the paper could
wrinkle or slip causing it to jam.)
NOTE 2. When the paper end mark appears on the paper, replace the roll
paper before it runs out.
Paper insetion
slit
Platen
Print head
(When using copying paper) (SP347)
Paper
outlet
– 10 –
Paper insertion
slit
Print head
C Pull on the edge of the paper to
remove any slack and then lower the
auto cutter.
D Insert the paper through the front
cover paper outlet and then replace
the front cover by reversing the re-
moval steps.
E To install the rear cover reverse the
removal steps.
Auto cutter
Upper paper
Lower paper
Platen