C SEED 125 User Instructions page 15

5.3 HOW TO SET UP THE ISLAND CONFIGURATION
To set up the island confi guration:
1. Make sure you have installed the speaker(s) according
to the instructions (see "How to install the C SEED 125
Speaker").
2. Make sure you have all components for the chosen set
up.
3. Place the control box and amplifi er (e.g. in the AV
room).
4. Place the receiver on an easily accessible location
(e.g. the living room).
5. Connect the Phoenix plug to the Phoenix connector on
your control box.
6. Connect the audio cable to the amplifi er.
7. Connect the amplifi er with the control box using a
network cable.
C SEED 125 SPEAKER
POWER cable 3x2,5mm²
DATA cable 18x0,5mm²
AUDIo cable 4x4mm²
POWER cable 3x2,5mm²
DATA cable 18x0,5mm²
AUDIo cable 4x4mm²
8. Connect the amplifi er to the receiver using an
XLR<->cinch cable for each channel separately.
9. Connect control box to the receiver using a network
cable.
10. Connect the amplifi er, control box and receiver to a
suitable and easily accessible wall socket.
11. Connect your audio source (e.g. USB, TV or airplay)
to the receiver.
12. Connect the control box to the router. Confi gure the
router. Note: if you don't have internet/wifi the system
can still be used. The control box sends out a wifi
signal. This signal can be detected by a mobile phone.
By using the app on your mobile phone you can control
the speakers through the control box.
14