Table of Contents
Advertisement
To install the speaker:
1. Attach the sling to the eye bolts (8). Attach the sling to the lifting
gear (crane or fork-lift truck). Place the speaker next to the desired
location.
2. Use a screwdriver to mount the Phoenix connector (7) to the shaft
(6). Place the seal between the Phoenix connector (7) and the
shaft (6).
3. Mark the route from the desired location of the speaker to the
location the control box (e.g. in the AV room).
4. Dig the trench for the cable. All local regulations must be followed.
5. Dig the speaker hole. See Appendix V for the installation drawings.
6. Put 200 mm gravel on the bottom of the hole for drainage.
7. Drive a conduit in the trench for the cable.
8. Run the cable through the conduit.
9. Continue running the cable through the house to the location of
the control box.
10. Place the speaker in the hole. Make sure to use lifting gear when
moving the speaker.
11
Advertisement
Table of Contents
