Table of Contents
Advertisement
5. HOW TO SET UP THE AUDIO SYSTEM
WARNING! The speaker must only be installed and connected by a qualifi ed and trained person.
5.1 CHOOSING YOUR CONFIGURATION (INTEGRATED OR ISLAND CONFIGURATION)
The C SEED 125 speaker can be integrated with an existing sound system (integrated setup) or can be used as a
stand-alone system (island setup). For the island setup you need a receiver. For the integrated setup, you can connect
the control box and the amplifi er to the existing home audio system.
5.2 HOW TO SET UP THE INTEGRATED CONFIGURATION
To set up the integrated confi guration:
1. Make sure you have installed the speaker(s) according to the instructions (see "How to install the C SEED 125
Speaker").
2. Make sure you have all components for the chosen set up.
3. Place the control box and amplifi er (e.g. in the AV room).
4. Connect the Phoenix plug to the Phoenix connector on your control box.
5. Connect the audio cable with the speakOn plug to the amplifi er.
6. Connect the amplifi er with the control box using a network cable.
7. Connect the amplifi er to the home audio system (e.g. the Crestron) using an XLR cable for each channel separately.
8. Connect the amplifi er and control box to a suitable and easily accessible wall socket.
9. Connect the control box to your home network with a router. Confi gure the router. Note: if you don't have internet/wifi
the system can still be used. The control box sends out a wifi signal. This signal can be detected by a mobile phone.
By using the app on your mobile phone you can control the speakers through the control box.
Router
POWER cable 3x2,5mm²
DATA cable 18x0,5mm²
AUDIo cable 4x4mm²
POWER cable 3x2,5mm²
DATA cable 18x0,5mm²
AUDIo cable 4x4mm²
13
Advertisement
Table of Contents
