ashtech Z-Xtreme Quick Start Manual page 4

Enter the SITE ID...
Refresh the LCD Display menu, press the ⇓ for 1 Second.
From the SYSINFO menu, press the ⇑, navigate the menu to SURVEY:STATIC..
At the SURVEY:STATIC menu, press the ⇓ for 3 seconds
(Move to Lower Menu).
Tap the ⇓ for 1 second (set display in Edit Mode).
The next prompt = SITE: ????
Enter the Alpha-Numeric 4-Character SITE ID using the combination of the ⇑ & ⇓
buttons. When each individual character is selected, press the ↵ for 1 Second
(Accept Changes).
Repeat this process for each character in the 4-Character SITE ID.
Upon completion of entering the 4-Character SITE ID, the LCD display menu will scroll
the entered SITE ID for confirmation. If you made a mistake entering the SITE ID,
simply depress the ⇓ for 1 second, re-enter the correct SITE ID.
If you have entered the correct 4-Character SITE ID, depress the ⇑ for 1 Second.
(Scroll Through Menu).
This will advance the LCD display menu to ANT HT menu...
The ANT HT: 02.0000m may have been pre-programmed in to the receiver memory.
If this is the case, verify the ANT HT is correct per the GPS Project instructions.
If the ANT HT is correct, simply bypass this menu by pressing the ⇑ for 1 second.
This will advance the LCD display menu to DESIRED VECTOR LENGTH menu...
Bypass this menu by pressing the ⇑ for 1 Second. (Scroll Through Menu).
Enter the ANT HT...
To input the ANT HT menu, Tap the ⇓ for 1 second (set display in Edit Mode).
Enter the correct ANT HT using the combination of the ⇑ & ⇓ buttons. When each
individual number character is selected, press the ↵ for 1 Second
(Accept Changes).
Repeat this process for each integer in the ANT HT.
4
Thales Navigation: ZX-Static Operations