ashtech Z-Xtreme Quick Start Manual page 3

Hide thumbs Also See for Z-Xtreme:

For Static Surveying Mode, the following items must be

Entered / Verified by the field surveyor:

• SITE ID (4-Character Site ID).

• ANTENNA HEIGHT (Antenna HI to ARP, in Meters).

• RECORDING INTERVAL (15 Second Record Interval).

See Z-Xtreme Quick Reference Card...

Ashtech Part Number 630846-01 Rev A

Monitoring via the Front Panel

• Turn on the receiver

POWER.

Apply power to the receiver by pressing the On/Off button. The unit displays CHECK,

And then the Main Menu SYSINFO...

If the Z-Xtreme does not detect the external GPS Antenna, an Alarm will sound (BEEP-BEEP-

BEEP...) and the LCD display menu will display the Warning: "NO ANTENNA DETECTED".

Ensure the Antenna cable is properly connected to the GPS Antenna and the GPS receiver. If both

of these cable connections seem OK, the antenna cable may be damaged and should be replaced.

To cancel the Alarm state, depress the ⇓ (Down Arrow) to re-fresh the LCD display window, then

depress the ⇓ (Down Arrow) again to cancel the Alarm.

At the SYSINFO menu, press the ⇑ (Up Arrow) for less than two seconds. Every time you press

⇑ , the unit displays a different menu in the following order:

SYSINFO -> SURVEY:STATIC -> SURVCONF -> SESSIONS -> SETTINGS...

For Static surveying, the GPS receiver / field operator MUST input the SITE ID, the

ANTENNA HEIGHT and the RECORD INTERVAL.

Some of these Parameters can be saved to memory, (Antenna Height & Record

Interval), But, it highly recommended the field operator input the SITE ID for each and

every station occupation.

Good field procedures, Input the SITE ID, then verify the proper Antenna Height and

Record Interval parameters are properly set per the GPS Project Manager's instructions.

Thales Navigation: ZX-Static Operations