Delay; Time; Regen; Amount - Roland SE-02 User Manual

DELAY

This section is where the settings for the delay are made.

TIME

Adjusts the delay time.
NOTE:the timing of the delay will change depending on the sync settings in the LFO section.

REGEN

Sets the number of repeats the delay reports. Setting this to full counter clockwise will produce minimal
repeats. Clockwise rotation will increase the number of repeats until a continuous report.

AMOUNT

This is the volume control for the DELAY. Full counter clockwise is essentially turning off the delay. As the
knob rotates clockwise, the volume of the DELAY increases to full volume.
Page 19 of 35 Manual V1.03 for firmware V1.11