AccuTemp Evolution Service Manual page 44

REVERSING THE DOOR
Should it be desired, the door orientation can be reversed.
1. Unplug the unit and shut the door.
2. Ensure the unit is cool and drained of water.
3. Remove the 3 hinge screws going into the face of the steamer of the Bottom
Hinge (FIG 4.5F).
4. While supporting the Door on the hinge-side, remove the 3 hinge screws into the
face of the steamer of the Top Hinge.
5. Pull the door handle and remove the Door.
6. Remove the two 3/8th sheet metal screws covering the latch strike plate
mounting holes on the hinge side.
7. Remove the six 3/8th screws covering the mounting holes opposite the hinges
(FIG 4.5F).
8. Remove the two Phillips Machine screws securing the latch strike plate and shim.
Set aside for later use.
9. Replace the eight 3/8th screws in the mounting holes vacated by the hinges and
strike plate.
10. Reinstall strike plate and shim in reverse order.
11. Reinstall door in reverse order - the latch handle will now face the opposite
direction than previously.
12. The door switch MUST be relocated to match the orientation of the latch.
Follow the instructions in Section 4.3
Door strike
plate and
spacer
SP8026-1909
'DOOR SWITCH' to transfer the switch
FIG 4.5F
EVOLUTION ELECTRIC STEAMER
8 x sheet
metal screws
44