AccuTemp Evolution Service Manual page 40

If Heater Studs are Discovered Broken While Removing the Cast Heater
If a Heater Stud Breaks-Off While Removing or Installing the Cast Heater
4.4E
14. Clean the studs so thread locker will adhere to them.
15. Lay the cast heater on a table with the smooth shiny side up. Wipe the surface
clean and apply 1.5 - 2.0 ounces of heat transfer compound to the smooth side
of the casting using the putty knife. Use the putty knife to spread the thermal
compound across the entire surface of the cast heater.
16. When the surface is covered, hold the fine tooth comb (included with the kit)
vertical and draw it along the length of the heater in several passes to obtain
an even, uniform thickness coating across the entire surface. After each pass,
remove excess compound with the putty knife. When finished it should look like
an even surface containing fine lines of the compound. If the lines of compound
do not cover, add additional compound in those areas and repeat.
Do not pick the heater up by the lead wires. Doing so may damage the
connections.
SP8026-1909
Call AccuTemp Service Dept (800) 480-0415.
EVOLUTION ELECTRIC STEAMER
OR
4.4B
4.4C
4.4D
4.4A
40