Initialization - Zhiyun Evolution User Manual

Initialize the stabilizer when any of the following circumstances occurs:
a)Slight deviation is found in the tilt angle of the camera in level position after startup.
b)Slight deviation is found in the roll angle of the camera in level position after startup.
c)Frequent small angle correction is found when the camera is in level position while the
stabilizer stays still.
If slight deviation can still be found after initialization, repeat the procedure above to initialize again.
Calibrate the stabilizer when any of the following circumstances occurs:
1. Deviation is found in the balancing of the camera even after initialization.
2. The stabilizer has not been used for a long time.
3. The stabilizer is exposed to severe temperature change (Calibration is required, as excessive temperature
differences in operation environments may affect various parameter indexes of the inner part of the built-in
gyroscope).
Initializing the Stabilizer
Initialization Procedure
1. Install the batteries and camera properly.
2. Put the stabilizer still on a table surface in random
pose.
3. Power on the stabilizer, wait for about 15 sec.,
and the stabilizer will automatically complete

initialization.

Off-line Calibration
Initialization
zhiyun-tech.com 16