Body Lubrication; Windshield Wiper Blades; Adding Washer Fluid - Jeep Cherokee Operating Information Manual

NOTE:
Use only manufacturer approved A/C sys-
tem sealers, stop leak products, seal condi-
tioners, compressor oil, and refrigerants.

Body Lubrication

Locks and all body pivot points, including such
items as seat tracks, door hinge pivot points
and rollers, liftgate, tailgate, sliding doors and
hood hinges, should be lubricated periodically
with a lithium based grease, such as MOPAR
Spray White Lube or equivalent, to assure
quiet, easy operation and to protect against
rust and wear. Prior to the application of any
lubricant, the parts concerned should be wiped
clean to remove dust and grit; after lubricating
excess oil and grease should be removed.
Particular attention should also be given to
hood latching components to ensure proper
function. When performing other underhood
services, the hood latch, release mechanism
and safety catch should be cleaned and lubri-
cated.
240
The external lock cylinders should be lubri-
cated twice a year, preferably in the Fall and
Spring. Apply a small amount of a high quality
lubricant, such as MOPAR Lock Cylinder Lu-
bricant or equivalent, directly into the lock
cylinder.

Windshield Wiper Blades

Clean the rubber edges of the wiper blades
and the windshield periodically with a sponge
or soft cloth and a mild non-abrasive cleaner.
This will remove accumulations of salt or road
film.
Operation of the wipers on dry glass for long
periods may cause deterioration of the wiper
blades. Always use washer fluid when using
the wipers to remove salt or dirt from a dry
windshield.
Avoid using the wiper blades to remove frost or
ice from the windshield. Keep the blade rubber
out of contact with petroleum products such as
engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies de-
pending on geographical area and fre-
quency of use. Poor performance of blades
may be present with chattering, marks, wa-
ter lines or wet spots. If any of these condi-
tions are present, clean the wiper blades or
replace as necessary.

Adding Washer Fluid

The fluid reservoir in the engine compartment
should be checked for fluid level at regular
intervals. Fill the reservoir with windshield
washer solvent/antifreeze (not radiator anti-
freeze). Operate the system for a few seconds
to flush out the residual water.
When refilling the washer fluid reservoir, apply
some washer fluid to a cloth or towel and wipe
the wiper blades clean. This will help blade
performance.
To prevent freeze-up of your windshield washer
system in cold weather, select a solution or
mixture that meets or exceeds the temperature
range of your climate. This rating information
can be found on most washer fluid containers.