To Lock The Doors And Liftgate - Jeep Cherokee Operating Information Manual

To Lock The Doors And Liftgate

Press and release the LOCK button on the RKE
transmitter to lock all doors and the liftgate. The
turn signal lights will flash to acknowledge the
lock signal.
Flash Lights With Lock
The feature will cause the turn signal lights to
flash when the doors are locked or unlocked
with the RKE transmitter. This feature can be
turned on or turned off. To change the current
setting, proceed as follows:
• For vehicles equipped with the Electronic
Vehicle Information Center (EVIC), refer to
"Electronic Vehicle Information
(EVIC)/Personal Settings
grammable Features)" in "Understanding
Your Instrument Panel" for further informa-
tion.
• For vehicles not equipped with the EVIC,
perform the following steps:
1. Press and hold the UNLOCK button on a
programmed (i.e. functional) RKE transmitter
for at least four seconds, but not longer than
18
10 seconds. Then, press and hold the RKE
transmitter LOCK button while still holding the
UNLOCK button.
2. Release both buttons at the same time.
3. Test the feature from outside the vehicle by
pressing the LOCK and UNLOCK buttons on
the RKE transmitter.
Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
Pressing the LOCK button on the RKE trans-
mitter while you are inside the vehicle will
Center activate the Vehicle Security Alarm. Opening
(Customer-Pro- a door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Press
the UNLOCK button to deactivate the ve-
hicle Security Alarm.
To Unlatch the Liftgate Flip-Up
Window
Press the Rear Release button twice to unlatch
the liftgate flip-up window.
WARNING!
To avoid injury stand back when opening.
Glass will automatically rise.
Programming Additional
Transmitters
Refer to Sentry Key "Customer Key Program-
ming."
If you do not have a programmed RKE trans-
mitter, contact your authorized dealer for de-
tails.
Battery Replacement
The recommended replacement battery is
CR2032.
NOTE:
• Do not touch the battery terminals that
are on the back housing or the printed
circuit board.
1. Remove the screw from the RKE transmitter
case (if equipped).