Base Construction And Installation Of The Outdoor Unit - Samsung AMxxxJXV Series Installation Manual

Base construction and installation of the outdoor unit

Make sure to remove the wooden pallet before installing the outdoor unit. If you do not remove
WARNING
with wooden pallet on, and it was used for long period time, wooden palette may break and cause
electrical hazard or high pressure may damage the pipes.
Manufacturer is not responsible for the damage occurred by not following the installation standards.
1. Make sure that the height of the base ground is 200mm or higher to protect the outdoor unit from rain
water or other external conditions. Also, install a draining pit around the base ground and connect the
drain pipe to the drainage.
2. Considering the vibration and weight of the outdoor unit, strength of the base ground must be strong to
3. Base ground should be 1.5 times larger than the bottom of the outdoor unit.
4.
5.
6. It is necessary to add wire mesh or steel bar during concrete construction for the base ground to prevent
damages or cracks.
7. When installing multiple outdoor units at the same place, construct an H beam or an anti-vibration frame
on the base ground to install the outdoor unit.
8. After installing an H beam or an anti-vibration frame, apply corrosion protection and other necessary
coating.
9. When concrete construction for outdoor unit installation is completed, install an anti-vibration pad
(t=20mm or more) or an anti-vibration frame to prevent vibration of the outdoor unit from transferring to
the base ground.
10.
(The bearing force has to be over 3.5kN)
Base ground construction
Over 200 mm
Draining pit
<When installing on the ground>
30
Bottom surface of the base
ground must be horizontally
leveled
Over 200 mm
<When installing on the roof>