Adding The Smart Water Valve To The Z-Wave Network; Troubleshooting; Removing The Valve From The Z-Wave Network - Alarm.Com Building36 Smart Water Valve Product Manual

10. Add the Smart Water Valve to the Z-Wave network (see "Adding the Valve to the Z-
Wave Network").

Adding the Smart Water Valve to the Z-Wave Network:

TIP: For best results, we recommend bringing the Z-Wave controller into the area where the Smart
Water Valve is installed.
1. Put the Z-Wave controller in ADD mode. Refer to controller documentation for more
information.
2. Press the Networking [Insert Radio Icon] button on the side of the Smart Water Valve
control unit to begin the ADD process. The NETWORK light on the control unit will
begin flashing.
3. After the Smart Water Valve is successfully added, the NETWORK light on the Smart
Water Valve will turn solid. If the NETWORK light is not illuminated after the add
process, repeat steps 1 and 2.
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers. All non-battery-operated nodes within the network will act as repeaters regardless of vendor to
increase reliability of the network.

Troubleshooting:

The Smart Water Valve is not communicating with the Z-Wave controller:
1. Try excluding the device from the network (see "Removing the Valve from the Z-Wave
Network") and re-adding it to the network.
2. If Step 1 does not resolve the issue, we recommend installing a Z-Wave Repeater
nearby and performing a Z-Wave network rediscovery.
TIP: Any wall powered Z-Wave device will act as a Repeater and improve the range
between the Z-Wave Controller and the Z-Wave device you are installing.

Removing the Valve from the Z-Wave Network:

TIP: For best results, we recommend bringing the Z-Wave controller into the area where the Smart
Water Valve is installed.
1. Put the Z-Wave controller in REMOVE mode. Refer to the controller documentation
for more information.
2. Press the Networking [Insert Radio Icon] button on the side of the Smart Water Valve
control unit to begin the remove process. The NETWORK light on the control unit will
begin flashing.
3. After the Smart Water Valve is successfully removed from the Z-Wave network, the
NETWORK light on the
illuminated after the removal process, repeat steps 1 and 2.
control unit will turn off. If the NETWORK light is still