Dimensions; Troubleshooting - SECO-LARM ENFORCER E-964-Q660Q Manual

Fig. 15: Dimensions
43ST Pole Size
Side View

Troubleshooting:

Transmitter LED not lit
_________________________________________________________________________________________________________________________________
Receiver LED does not light when interrupted
_________________________________________________________________________________________________________________________________
Beams are interrupted and LED lights, but the
alarm does not trigger.
_________________________________________________________________________________________________________________________________
Signal LED continuously lit
_________________________________________________________________________________________________________________________________
Alarm trigger becomes erratic in bad weather
_________________________________________________________________________________________________________________________________
Frequent false alarm triggers
®
SECO-LARM U.S.A.
ENFORCER Quad-Photobeam Detectors
4 / "
11
32
(110mm)
Upper
View
4 / "
7
16
(113mm)
Front View
Make sure the input power to the transmitter is
12 to 24 VAC/VDC.
Check the input power to the receiver is 12 to 24
VAC/VDC.
Check the continuity of the wiring from the
receiver to the alarm.
Clear any obstacles between the transmitter and
receiver.
Clean the lenses of both units.
Check overall system installation.
Realign the lenses.
Adjust the response time.
Change location of transmitter and receiver.
Rear View
11