Limit Of Grinding Wheel Descent; Adaptation Kit For Harmonic Grinding; Adaptation Kit For Grooved Rail Grinding; Supplies - GEISMAR STUMEC MP.12 Instruction Manual

6.1.8 Limit of grinding wheel descent

Grinding wheel descent limiter (ref. 37000 JZ)

6.1.9 Adaptation kit for harmonic grinding

Harmonic wear grinding to convert a MP12 into a MOD12 with balancing bar (Ref. 37000 BH and 37000 K)

6.1.10 Adaptation kit for grooved rail grinding

The machine must be equipped with a Ø 80mm grinding wheel and housing if the same diameter for proper rail grinding.
Grinding wheel housing (ref. 37101)
6 Ø 80 x 72 – M20-type sliding grinding wheel (ref. N03313)
Roller device for moving from grooved rails to flat-bottomed rails (ref. 37000 BB)

6.1.11 Supplies

Reinforced resin sliding grinding wheel for:
M8 4-hole wheel holder plate:
−
150 x 72 mm (code N00734);
−
125 x 60 mm (code N00733);
M8 6-hole wheel holder plate:
−
150 x 65 mm (code N00738);
M20 wheel holder plate or nozzle:
−
125 x 65 mm (code N02780);
−
80 x 72 mm (code N03313);
5/8'' wheel holder nozzle:
−
150 x 65 mm (code N00737);
−
80 x 72 mm (code N00731);
−
6'' x 3'' (code N03243).
6.1
Wheel holder nozzles and plates (accessories):
5/8'' wheel holder nozzle (ref. 16356):
M20 wheel holder nozzle (ref. 16356 A):
Ø125 - M20 wheel holder plate (ref. 16356 C);
4-hole wheel holder plate (M8 bolt) (ref. 37042).
6-hole wheel holder plate (M8 bolt) (ref. 37006).
MP12_Gb_00610_090701.doc
6.1