Filtering - GEISMAR STUMEC MP.12 Instruction Manual

To guarantee proper alignment of the drive belt, you must carry out the same adjustment on each of the pulleys.
When there are no more clamps between the flanges of the two pulleys and the belt is slipping, a new belt must be installed in its place.
To install a new belt, put all of the clamps (12 per pulley) between the pulley flanges.
NOTE: When replacing or re-installing a belt, check that the pulley grooves are in good condition and clean them, and those of the belt, carefully.
Check the belt tension after 10 hours of use, then check and adjust it, if necessary, after every 50 hours of use.

5.1.6 Filtering

A clogged filtration system can cause the following problems:
• excessive fuel consumption
• problems starting the motor
• decreased motor power
• premature wear to the motor
At the end of each work day (or every time it should prove necessary):
➊ Remove the air filter cover.
➋ Clean the filter box and surroundings, as well as the inside of the filter cover. Use compressed air for this, taking care not to point the air flow directly
at the main filter.
➌ Refit the air filter and filter cover.
You must replace the two filtration components in the event of clogging or damage.
To prevent particles from entering the inlet, you must replace the filter in a clean environment, such as a warehouse or maintenance workshop.
5.1
NEVER USE THE MACHINE WITHOUT THE AIR FILTER
MP12_Gb_00603_090701.doc
5.1