Handle - GEISMAR STUMEC MP.12 Instruction Manual

Power take-off device (ref. 37000 DS – original component supplement)
Hoses (for use with grinding wheel holders)
Hose without clutch:
−
Length 3 m (ref. 16300 A);
−
Length 4 m (ref. 16300 B);
Hose with clutch
(Mandatory for EC machines equipped with power-take-off device):
−
Length 3 m (ref. 16300 E);
−
Length 4 m (ref. 16300 G);
Reinforced resin grinding wheel (for wheel holder with hose)
For straight 230 x 20 x 16 mm wheel holder (code N00742);
For square-shaft 230 x 6.4 x 22.2 mm wheel holder (code N00730) ;
For square-shaft 150 x 72 mm wheel holder (code N00734);
Wheel holders for hoses:
Straight wheel-holder for grinding inside rail equipment, crossing and ends (ref. 600 W);
Square shaft wheel holder, for grinding welds (ref. 600 X);
Square shaft wheel holder, for grinding welds (ref. 600 Y);

6.1.2 Handle

Carrying handle (ref. 37464)
Minsel engine carrying handle (ref. 37000 KK)
Bernard engine carrying handle (ref. 37000 MC)
6.1
6.1.3 Spacing extension
Spacing extension (ref. 37000 V)
MP12_Gb_00608_090701.doc
6.1