Table of Contents
Advertisement
Note:
Frequency ID and wave ID cannot be operated at the same time.
To avoid risk of serious eye damage, please do not look into the
optical port of laser source at any time.
6.8 Power off
Automatic power off: When auto-off function is activated, the unit will turn
itself off automatically after 10minutes idle time, whatever the power supply
is with alkaline batteries or is with power supply adaptor directly.
Manual power off: Under any operation mode, hold down
seconds to turn the unit off.
Note: With either power off operation, the unit will store the last calibration
wavelength and backlight control mode automatically, which will be the
default setting when user turns unit on next time.
Chapter 7 Troubleshooting
Problems
Faint display on the
LCD screen
Inaccurate
measurements
www.suntelecom.cn • +86-21-60138638 • ics@suntelecom.cn
F i b e r O p t i c S o l u t i o n s P r o v i d e r
Possible cause
1.
Power is off
2.
The battery power
is too low
1. Optical connector is
not clean.
2. incorrect fiber
connection
6-32
1.
Press
2.
Change the batteries
1.
Clean optical connectors
2.
Re-connect the fiber
51/54
for a few
Solution
key.
Advertisement
Table of Contents
