Sun Microsystems SUN-OPM200 Series User Manual page 54


Enable light source be Under "Wave ID" operation mode: press
light source to emerge light output from light source. Hold down
for few seconds, light source will be enter into Wave ID mode, also
"—AU" will be shown on the upper right of LCD for an indication.

Enable power meter be under "Wave ID" operation mode: Hold down
for few seconds, power meter will be enter into Wave ID mode,
also "—AU" will be shown on the upper right of LCD for an indication.

Once the ID information is changed from light source (press
change wavelength), after 3 to 5 seconds later, the detected information
on optical power meter also will be changed automatically according to
light source. Please refer to below figure (6-31) for easy understanding.

Exit Wave ID mode: Hold down
power meter and hold down
source.
SUN-LS200 Light Source
www.suntelecom.cn • +86-21-60138638 • ics@suntelecom.cn
F i b e r O p t i c S o l u t i o n s P r o v i d e r
again to exit Wave ID mode from
again to exit Wave ID mode from light
Power Meter
6-31
49/54
of
to