Digital Equipment DECstation 5000 Upgrade Instructions page 7

Remove the Front Drive Panel
1. Loosen the two captive screws that hold
the front drive panel in place.
2. Loosen the two captive screws on the
back of the drive bracket.
3. If there is a drive inside the bracket, dis-
connect the SCSI and power cables from
the drive.
Captive
Screws
4. Pull up carefully from the back of the
drive bracket. As you raise the end of the
bracket, you can pull the disconnected
ends of the cables through the cutout in
the bracket.
5. Release the cables from the cable clamps
on the inside of the front panel.
6. Set the front panel aside. Handle it
carefully if it contains a drive.
Captive
Screws
MLO-010666