Digital Equipment DECstation 5000 Upgrade Instructions page 5

Record Your System SCSI IDs
If your DEC 3000 system has a factory-
installed drive, you may need to change the
SCSI ID setting on the drive you upgrade.
To display the SCSI ID settings of the drives
in your DECstation system:
1. Enter the following command to shut
down the software and put the system in
console mode: shutdown -h now
2. Enter the cnfg 3 command at the
console prompt (>>). A screen similar to
the following displays:
>>cnfg 3
3: KN02 DEC Vn.n TCF0
(enet:
----------------------------------------------
DEV PID VID
==============================================
rz2 RZ24 (C) DEC DEC 0700
rz5 RRD42 (C) DEC DEC 0700
.
.
This example display shows an RZ24 drive
set to SCSI ID 2 and an RRD42 drive set to
SCSI ID 5.
Write down your system drive names and
SCSI ID settings here:
(8 MB)
08-00-2b-30-14-df)
(SCSI = 7)
REV SCSI ID
DIR
CD-ROM