Setting Scan Options - Realistic HTX-202 Manual

M4 225.7 34
M5 233.6 35
M6 241.8 36
M7 250.3 37

SETTING SCAN OPTIONS

Several configuration menu items control how your transceiver operates
when you scan frequencies or memories. The following sections describe
how
to set the frequency step rate, the scan condition, the scan delay
duration, and the scan limits.
SETTING THE FREQUENCY STEP RATE
The frequency step rate affects the scanning mode, the TUNE control, and
/\SC or \/SC tuning. The factory default for the frequency step is 15kHz.
Each time you rotate TUNE one click or \/SC or /\SC the frequency
changes by 15 kHz. When scanning, the transceiver scans up or down 15
kHz
step. To change the frequency step rate, follow the steps in
"Understanding the Configuration Menu" to display the Sr menu item, and
rotate TUNE to change the frequency step rate. You can set the step rate
to 5, 10, 15, 25, 50, or 100 kHz.
SETTING THE SCAN RESUME CONDITION
When you have set the transceiver to receive either standard memories or VF
mode, the transceiver stops whenever it encounters a signal strong enough
to break squelch. At the factory setting, the transceiver resumes scanning
in 10 seconds, regardless of the of the presence of a continued signal.
You can set the scan resume configuration item to one of the following.
ti Resumes scanning in 10 seconds
cr Resumes scanning after the carrier drops and the scan delays
expires (See "Setting the Scan Delay.")
SE Does not resume scanning