Realistic 120-1451 User Manual
Realistic 120-1451 User Manual

Realistic 120-1451 User Manual

Stereo three am/fm radio

Advertisement

(120-1451)
Your REALISTIC Stereo Three is a complete solid-state 3-piece FM/AM Stereo
System.
Its size and styling will fit well in any room or location in your
home or at the office.
finished, mar proof surface.
efficiency permanent-magnet dynamic speakers and have been specially
designed to match the tuner/amplifier, both in appearance and electrical-
acoustical performance.

FEATURES

Complete FM/AM Stereo System
Bookshelf size
Inputs for Phono and Tape
Automatic Stereo Indicator Light
Lighted Slide Rule Dial
Stereo Headphone Jack
Balance Control for Optimum Stereo Separation
Built-In Antenna for both AM and FM, plus terminals for connecting an
external FM antenna (for superior reception)
Solid-State Circuitry with 18 Transistors and 16 Diodes (including 3
in power circuit)
Features
Each of the three pieces is finished in a walnut
The stereo speaker cabinets house high-
Faxback Doc. # 18906

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 120-1451 and is the answer not in the manual?

Questions and answers

Summary of Contents for Realistic 120-1451

  • Page 1 REALISTIC Stereo Three AM/FM Radio (120-1451) Your REALISTIC Stereo Three is a complete solid-state 3-piece FM/AM Stereo System. Its size and styling will fit well in any room or location in your home or at the office. finished, mar proof surface.
  • Page 2 REALISTIC Stereo Three AM/FM Radio (120-1451) CONTROLS: LOCATION AND FUNCTION Tuning - is used to tune the Receiver to the desired AM, Stereo Indicator Light - lights up automatically when you are tuned to an Selector Switch - determines the function of the receiver: TONE Control - adjusts the tonal response of both channels.
  • Page 3 SPEAKERS - connect speaker cables between the jack on the When phones are plugged in, the speakers are automatically disconnected. Shack Catalog Number 33-1038 or 33-195; your Radio Shack store has a complete selection of Stereo Headphones. Speakers; connect R jack to the speaker positioned at the right of your listening position and L jack to the left speaker.
  • Page 4 FM dipole or other FM antenna. Or, you can obtain a "signal splitter" and use your present TV antenna. Radio Shack store for help. a ceramic cartridge, you can play records though your system. Connect the cables from your...
  • Page 5 REALISTIC Stereo Three AM/FM Radio (120-1451) Be sure all equipment is connected as described previously and as shown in the illustration. Do not operate the Stereo Three without speakers properly connected. Extend the AC line cord to its full length (to assure maximum benefit from the FM Line Cord Antenna) and plug it into a source of 120 volts, 60 Hz AC power.
  • Page 6 Place a disc on your Record Changer/Turntable and activate it. Adjust VOLUME, TONE and BALANCE for best sound. NOTE: Only a Record Changer/Turntable with a ceramic cartridge will function with this system. TAPE Operation If you have cables connected from a Tape Deck with an output of approximately 1/2-volt to the TAPE jacks on the rear of the unit, set the Selector switch to TAPE.
  • Page 7 REALISTIC Stereo Three AM/FM Radio (120-1451) AM Section Frequency Coverage:...520 to 1600 kHz Intermediate Frequency:...455 kHz FM Section Frequency Coverage:...88 to 108 MHz Intermediate Frequency:...10.7 MHz Sensitivity:...8 microV or better Stereo Separation:...28 dB or better at 1000 Hz Audio Section Output Power:...2.5 watts per channel...
  • Page 8 Dimensions: Receiver:...9 1/2" (h) x 6 3/4" (w) x 4 3/4" (d) Speaker Box (2 pcs.):...each same as receiver Weight: Receiver:...4.85 lbs. Speaker Box:...1.97 lbs. each. (SP/all-02/08/96) LN-03/04 Tape jacks External antenna balanced 300 ohms Headphones jack...

Table of Contents

Save PDF