Using The Light; Selecting A Frequency - Realistic HTX-202 Manual

transceiver.
1. Turn off the transceiver.
2. Press and hold down F+CLR. Then, turn on the transceiver.

USING THE LIGHT

Press L on the side of the transceiver to turn on the display light for
about 5 seconds. To turn the light off sooner, press L again. The light
stays on until you press L or turn off the transceiver.
Operation
SETTING SQUELCH AND VOLUME
Rotate VOLUME clockwise and SQUELCH counterclockwise until you hear a
hissing sound. Then, slowly rotate SQUELCH clockwise until the noise
stops. Leave VOLUME set to a comfortable level.
If the transceiver picks up unwanted weak transmissions, rotate SQUELCH
clockwise to decrease the transceiver's sensitivity to signals.

SELECTING A FREQUENCY

You can use any of three methods to select a frequency to communicate on.
Direct entry
Tune control
Scanning for frequencies
TUNING USING DIRECT ENTRY
Your transceivers transmits and receives on frequencies between 144.000
and 148.000 MHz. To quickly tune to a frequency, enter the frequency
using the keypad.