Guarantee; Disposal - Dometic WAECO MagicSpeed CBI 150 Installation And Operating Manual

_IA_Can Interface.book Seite 10 Montag, 29. November 2010 5:02 17

Guarantee

Status LED flashes: the vehicle type has been recognised
You can use the CAN bus interface.
You can test the functions as follows:
➤
Switch the ignition and all the consumer units off.
➤
Remove the ignition key.
➤
Close and lock all the vehicle doors.
✓
The status LED goes out after a delay time (depending on the model).
Status LED is lit: the vehicle type is not recognised
➤ Check whether:
– the vehicle type is included in the vehicle list.
– the CAN bus cables are correctly connected.
– the CAN bus cables are detected in the right position in the vehicle (see ve-
hicle list)
Status LED is switched off
➤ Check whether:
– the power supply is 12 V
– the CAN bus cables are correctly connected.
7 Guarantee
The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the
addresses) or your retailer.
For repair and guarantee processing, please send the following items:
Defect components
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
8

Disposal

➤
Place the packaging material in the appropriate recycling waste bins wherever
possible.
If you wish to finally dispose of the product, ask your local recycling centre
M
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
10
MagicSpeed CBI 150