Can Bus Interface; Connecting The Can Bus Interface - Dometic WAECO MagicSpeed CBI 150 Installation And Operating Manual

_IA_Can Interface.book Seite 9 Montag, 29. November 2010 5:02 17
MagicSpeed CBI 150
5

CAN bus interface

See Abb. 4
No. Designation
1 Pink cable: "Handbrake applied" signal
2 Brown cable: "Reverse gear engaged" signal
3 Violet cable: "Ignition switched on" signal
4 Green cable: Speedometer signal
5 Yellow cable: Engine speed signal
6 Orange cable: "Clutch applied" signal
7 White cable: Connection to CAN High
8 Blue cable: Connection to CAN Low
9 Black cable: Connection to earth
10 Red cable: Connection to a cable which is protected with max. 5 A
6

Connecting the CAN bus interface

NOTE
I
The configuration of the OBD-II plug can be found in Abb. 6.
Supplementary to Abb. 5
➤
Before installation, make sure that the output signals you need for your vehicle
are available from CBI150.
You can find a detailed vehicle list at:
htp://www.dometic-waeco.de/cbi150.
NOTE
I
Only connect the cables to the CAN bus cables in the vehicle which are
specified in the vehicle list.
➤
Connect the white and the blue cables with the CAN bus cables as described in
the vehicle list.
➤
Insert the plug of the connection cable into the socket of the CAN bus interface.
➤
Switch on the ignition.
✓ The status LED indicates the system status.
CAN bus interface
9