Setting The Dip Switches - JRC JSS-2150 Installation Manual

2.2.11.3 Setting the DIP switch
When connecting the printer (NKG-800) to the JSS-2150, set the DIP switches as follows.
Open the printer cover, remove the ink ribbon cartridge, and use your hand to move the print
①
head to the far right.
② Grab the protrusion on the compartment cover and remove by sliding it to the left.
③ Turn all the DIP switches off.
Note: Set the NKG-800 DIP switches as follows according to the device it is connected to.
Connected device
NCM-2150 (JSS-2150)
NCT-196(N)/ NDZ-127J (JSS-x96)
NCT-620D (JSS-825D)
NCH-851/852 (JSS-850)
NCH-1961/1962 (JSS-x96)
NDZ-127C (JUE-75C)
NDZ-127N (JSS-825NA/NC)
Replace the parts described above and the cover.
④
Print head
Compartment cover
DIP switch setting
INSTALLATIONS
2-67