Connecting The Signal Lines - JRC JSS-2150 Installation Manual

INSTALLATIONS

2.2.10.2 Connecting the signal lines

• Back of DPU-414
Printer cable
• Back of MF/HF controller (NCM-2150)
Serial connector cover
2-64
GND
Printer cable:
7ZCJD0254A
(1.5 m)
Printer power cable:
7ZCJD0257C (1.5 m)
Printer power cover
Cable clamp
Remove the serial connector cover and the cover
over the printer power source. Then connect the
printer connection cable and the printer power
cable.
After connecting the power cable, fix it with the
cable clamp and replace the cover over the printer
power source.
Note) When the DPU-414 is installed, set the
printer power
default). For details of the printer power
supply setting, see the NKG-800 section.
Printer power cable
DC 6.5 V, 2 A
-
+
supply to 6.5V (factory
DC 6.5 V
max. 2 A
(for printer)