Set Up And Operation - Shop-Vac Shop-Pac SP Series User Manual

INSTALLING THE ELBOW
1. Position elbow over inlet so threaded part of elbow faces top of the tank.
2. Push elbow into inlet as firmly as possible so notch on elbow lines up with notch
on inlet.
3. Turn elbow so threaded part of elbow faces bottom of tank.
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover on tank by sliding top of tank in groove on tank cover, located on the side containing the
blower port. Make sure the cover is fully covering the entire rim of the tank. Apply pressure with thumbs to
each latch until it snaps into place. Make sure both lid latches are clamped securely.
3. Insert long machine hose end with locking-nut into inlet of tank and tighten. Do not over-tighten.
4. Loosen the harness shoulder straps and hip belt.
5. In an open area lift the unit by a shoulder strap and slide your arm through the strap.
Then place your other arm through the other shoulder strap.
6. Wrap the hip belt around your waste and secure with belt clip.
7. Tighten the hip belt securely and make sure the weight is evenly distributed on your hips.
Adjust shoulder straps for a proper fit.
8. Place cord between the hip belt's strap and padded area to signal when you have run out of
cord while vacuuming. NOTE: The ON/OFF switch can be conveniently placed on
left side of hip belt for easy access.
9. Attach the extension wands to the accessory end of the hose.
10. Attach one of the cleaning accessories (depending on your cleaning requirements) on the
extension wands.
11. Plug the cord into the wall outlet. Your cleaner is ready for use.
NOTE: USE VAC FOR DRY PICK UP ONLY.
I = ON, O = OFF
NOTE: MANY MORE USEFUL TOOLS ARE AVAILABLE AT YOUR LOCAL DEALER OR SHOP-VAC ® WEBSITE.
PAGE 8
ASSEMBLY (CONT'D.)

SET UP AND OPERATION

–
This equipment incorporates parts such as switches, motors or the