Table of Contents
Advertisement
28
www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows an error
code that is not in this table.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The display shows "12.00".
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
Possible cause
The Child Lock is on.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
There is an electrical fault.
The demo mode is activa-
ted.
There was a power cut.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
Remedy
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
1. Deactivate the oven.
2. Press and hold the but-
ton
.
3. The first digit on the dis-
play and Demo indicator
start to blink.
4. Enter the code 2468 by
pressing the buttons
or
to change the val-
ues and press
firm.
5. The next digit starts to
blink.
6. Demo mode deactivates
when you confirm the
last digit and the code is
correct.
Reset the clock.
to con-
Advertisement
Table of Contents
