How To Configure And Assign - Siemens SIMATIC S7-300 Quick Start Manual

How to Configure and Assign Parameters
Prerequisites Before you can enter a new configuration and assign parameters to the CPU
of your S7-300, you must have created a project and selected the object that
you want to configure (here, your SIMATIC 300 station).
To make sure that there are no 'old' blocks in your CPU, you should perform
a memory reset before downloading the new configuration to the CPU.
Basic Procedure We aim to show you the basic procedure for configuring and assigning
parameters using the TLIGHT sample program. The figure below gives you
an overview of this procedure:
Figure 5-1
Since you have already created
the TLIGHT project, you can start
right away with the memory
Primer: S7-300 Programmable Controller, Quick Start
C79000-G7076-C500-01
Configuring and Assigning Parameters to Your S7-300
Procedure for configuring and assigning parameters
Reset CPU memory
Configure and assign parameters to the CPU
Save configuration table
Download the configuration to your S7-300
Procedure for Configuring and Assigning Parameters
reset of your S7-300!
5-3