Page 1
RE-1K • RE-2K RADIO REMOTE CONTROLLER re12k_en 05/18 The RE-1K / RE-2K controller allows you to use keyfobs to control devices connected to relay outputs. 1. Features 1 [RE-1K] or 2 [RE-2K] control channels. Support for up to 16 keyfobs.
Page 2
C1, C2 NC1, NC2 - relay output normally closed contact. NO1, NO2 - relay output normally open contact. Note: The RE-1K controller has no terminals of relay output 2. 3. Keyfobs The controller supports the following SATEL 433 MHz keyfobs: MPT-300 –...
Page 3
SATEL RE-1K • RE-2K The controller should be installed indoors, in spaces with normal air humidity. When selecting the installation place, take into consideration that thick walls, metal partitions, etc. will reduce the radio signal range. It is recommended that the controller be mounted high above the floor.
Dimensions ..................... 35 x 70 x 15 mm Weight..........................27 g Hereby, SATEL sp. z o.o., declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at www.satel.eu/ce SATEL sp.