Table of Contents
Advertisement
Apply the Fluid
1. To achieve the best results when applying fluid, keep
the gun perpendicular to the surface and maintain a
consistent distance of approximately 6 to 8 inches
(150 to 200 mm) from the object being sprayed. See
Fig 3.
2. To obtain an even finish, use smooth, even strokes
across the object being sprayed with 50% overlap.
3. Paint using parallel strokes. This spray gun applies
all coatings evenly without cross coating.
WRONG
Fig 3
OPERATION
NOTE: To eliminate the need to shut off the air pressure
at the air supply, install One-way Shut-off Valve
110–367 in the gun' s quick disconnect. See
ACCESSORIES.
If the one-way shut-of f valve is installed in the
gun line, allow for a 0.5 psi (0.035 bar) air pres-
sure drop to the gun, due to increased restriction
of the air line.
90
6–8 in.
(150–200 mm)
RIGHT
Advertisement
Table of Contents
