Troubleshooting - Zanussi ZOU30601XK User Manual

Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel frame
on the screen-printing zones is not rough when
you touch it.
Make sure that you install the internal glass
panel in the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The cooking zones do not oper-
ate.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
16
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
A
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking surface.
The oven is deactivated.
The fuse is blown.
The lamp is defective.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
deactivate the circuit breaker.
to remove it.
heat-resistant lamp.
Activate the oven.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Remedy
www.zanussi.com