Table of Contents
Advertisement
iStartSmart AIO Installation Manual
3.4.
Mount the Desktop and Install Wheels
``
5. Insert (2)XBHD 1 9/16" Decorative Screws
through the center of the printer shelf and
secure it to the vertical riser below.
6. Tighten the screws with 1 XAUS 4mm hex
wrench that is included in the desk hardware.
1. Retrieve the top of the desk, and place face
down on the floor (the 5 pre-drilled
mounting holes should be facing up). Place
the base assembly onto the bottom of the
desk top. The two curved surfaces go on the
same side. Align the 5 screw holes.
14
Advertisement
Table of Contents
