VTech VM352-2 Quick Start Manual

Go to www.vtechphones.com VM352-2
to register your product for
enhanced warranty support and
latest VTech product news.
Quick start guide
Connect and power on - Baby unit
Change different views - Single CAM
Select Single CAM as your monitoring mode to view a
Monitoring Mode
single baby unit in full screen.
Single CAM
Patrol
Split
Change different views - Split
Select Split as your monitoring mode to view the images
Monitoring Mode
from both baby units at once.
Single CAM
Patrol
Split
What's in the box
Positioning - Baby unit Install the battery
>
3ft (1m)
Change different views - Patrol
Select Patrol as your monitoring mode to alternately view the
Monitoring Mode
image from baby units and every 10 seconds.
Single CAM
Patrol
Split
10s
VM352-2 baby monitor system
Baby's room
Connect and power on - Parent unit
THIS SIDE UP
>
3ft (1m)
>
3ft (1m)
CAUTION
• The default volume of your parent unit is
level 4, and the maximum volume is level 7.
If you experience high-pitched screeching
noise from your baby monitor while
< positioning:
< 3ft (1m)
3ft (1m)
- Make sure your baby unit and parent unit are
more than 3 feet (1 meter) apart, OR
- Turn down the volume of your parent unit.
Change different views
In Single CAM or Patrol mode, press VIEW to switch between the image of baby units
Press VIEW
Install the lens (optional)
The wide-angle lens (VM101) provided allows you to view If you do not use the lens at the moment, cover both
more of your baby's room from the parent unit screen. sides of the lens with the lens covers provided to avoid
scratches.
Living room
5
Status check
Once you power on both your baby units and parent unit, your parent unit displays image from the baby unit, and
the LINK LED light turns on.
Long press
If you are viewing baby unit , the ON/OFF LED light of baby unit
its ON/OFF LED light flashes.
Dim mode
With dim mode preset to on, your
and .
parent unit display will dim to
conserve energy after 10 minutes
Brightness
of inactivity, in which there is
neither key pressed nor alert
Dim Mode
received from the baby unit.
10 min inactivity
Press any buttons
NOTES
If you do not want LCD to dim automatically, turn off the Dim Mode.
•
turns on. As baby unit is not being viewed,
LCD Dim Mode
On