Accessories; Correction Of Malfunctions - WAGNER W 575 FLEXIO Operating Instructions Manual

W 575 Flexio

20. Accessories

Wagner's unique Click & Paint System means additional spray attachments can be
purchased to suit a variety of different projects and surfaces.
Further information about the range of suitable accessories can be found at
www.wagneraustralia.com.au

21. Correction of Malfunctions

Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Atomisation too
coarse
Spray jet pulsates
Cause
•
Device not switched on
•
Nozzle clogged
•
Feed tube clogged
•
Material quantity too small
•
Feed tube loose
•
No pressure build-up in container
•
Ventilating bore (Fig. 11, 1)
clogged
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
•
Coating material too thick
•
Material volume too large
•
Nozzle clogged
•
Air cap assembled incorrectly
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Amount of air too low
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
Remedy
➞ Press the ON/OFF switch
on the side of the device
➞ Clean
➞ Clean
➞ Increase the quantity
of material
➞ Insert
➞ Tighten container
➞ Clean
➞ Tighten
➞ Change
➞ Change
➞ Clean
➞ Dilute
➞ Reduce the material
volume
➞ Clean
➞ Snap air cap properly
into place (fig. 16, 2)
➞ Change
➞ Tighten container
➞ Increase air quantity
(Level: II)
➞ Refill
➞ Change
➞ Change
AUS
21