WAGNER W 575 FLEXIO Operating Instructions Manual page 11

W 575 Flexio
2. Electrical Safety
a) The connection plug of the power tool must fit in the socket. The plug may not
be modified in any form. Verwenden Sie keine Adapterstecker gemeinsam mit
schutzgeerdeten Elektrowerkzeugen. Unmodified plugs and suitable sockets reduce
the risk of an electric shock.
b) Avoid physical contact with earthed surfaces such as pipes, heating elements,
stoves and refrigerators. The risk through electric shock increases if your body is
earthed.
c) Keep power tools away from rain or moisture. Water penetrating into a power tool
increases the risk of an electric shock.
d) Do not misuse the power cord to carry the power tool, hang up the power tool
or pull the plug out of the socket. Keep the power cord away from heat, oil,
sharp edges or moving parts. Damaged or entangled power cords increase the risk
of an electric shock.
e) If you are working with a power tool outdoors, only use extension cords that
are suitable for the outdoor area. Using an extension cord that is suitable for the
outdoor area reduces the risk of an electric shock.
f) If the power tool must be used in a moist environment, use a ground fault
circuit interrupter. Using a residual current operated circuit-breaker avoids the risk
of electric shock.
3. Safety of Persons
a) Be attentive. Pay attention to what you are doing and work sensibly with a
power tool. Do not use the power tool if you are tired or under the influence
of drugs, alcohol or medication. One moment of carelessness when using the power
tool may cause serious injuries.
b) Wear personal safety equipment and always wear safety goggles Wearing
personal protective equipment, such as dust mask, non-slip safety shoes, safety helm
or ear protection, depending on the type of power tools, reduces the risk of injury.
c) Avoid accidental starting-up. Make sure that the power tool is switched off
before you connect it to the power tool and/or battery, pick it up or carry it.
Accidents may happen if you have your finger on the switch while carrying the power
tool or if the device is switched on when you connect it to the power supply.
d) Remove setting tools or wrenches before switching on the power tool. A tool
or key in a rotating part of the power tool can cause injuries.
AUS
11