Possible Problems And Solutions; Power Indicator Does Not Illuminate; Pcriiplus Resets Suddenly - AGFA PCR II Plus User Manual

Possible Problems and Solutions

This section provides troubleshooting techniques to help you isolate
and correct problems you may encounter during normal operation of
the film recorder. If you encounter a problem that you cannot fix, call
for service.
WARNING:
There are no user-serviceable parts inside the PCR
II Plus. Never remove the side cover to access inte-
rior components.

Power Indicator Does Not Illuminate

If the PCR II Plus does not turn on, then the power cord may not be
plugged into an outlet that provides the proper line voltage. If the power
cord connection appears to be good, then one of the film recorder's in-
ternal fuses may be blown. Contact an authorized service representa-
tive for the proper procedures to replace a blown fuse.
PCR II Plus Resets Suddenly
A sudden hardware reset may occur if there are transient voltage
spikes or a brown-out condition on the AC power line. The PCR II Plus
should have its own dedicated power line with surge protection. Un-
plug any other equipment that uses the same power outlet as the PCR
II Plus and be sure your setup complies with the electrical and envi-
ronmental specifications given in the Appendix of this manual.
7-4 • PCR II Plus User Guide