User's Manual
5.8.1
Load Factory Default
This item is used to load the factory default setting. Select <Yes> to recall the
factory default setup configuration from the "read-only" memory, or select
<No> to cancel.
5.8.2
Import Configuration
This item allows the user to load a unit configuration that was saved on an
external drive. To import a configuration that was previously exported, make
sure the device that saved the configuration is connected to the unit. Select
<Import Config> from the Configuration menu and press ENTER. The
following menu is displayed.
Press UP / DOWN to select one of the available listed configuration files, and
choose <Yes> to start importing.
5.8.3
Export Configuration
The account with appropriate privilege can save a unit configuration by
exporting it to an external drive, such as a USB Flash Drive. Before exporting
the configuration, make sure the device in which the configuration will be
saved is attached to the unit properly. Select <Export Config> from the
Configuration menu and press ENTER. The following menu is displayed.
Items in this menu are described in the following sections.
118
Config Name
xxxx-xxxx
xxx-xx
NOTE: If the imported configuration has a different record mode from
the unit's, the warning message "This config has different record mode.
This will FORMAT ALL HARDDISKS." will show.
NOTE:
Remove
configuration after the unit restarts, or it will be formatted as well.
Copy Destination
Config Name
Begin Export
Import Config
the
ThumbDrive
Export Config
Select
No
No
®
used
for
importing
No
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 07/10