Wood Handle & Door Assembly - Regency F2500 Owners & Installation Manual

installation
Wood Handle & Door Assembly
WOOD DOOR & HANDLE ASSEMBLY
1. In preparation of installing the door handle, the nuts,
cam, washers and spacer must be removed as shown in
Diagram 1.
Cam
Nuts
LATCH ADJUSTMENT
The door latch may require adjustment as the door gasket
material compresses over time. Removal of 1 or 2 wash-
ers will allow the latch to move closer to the door frame,
causing a tighter seal. (Refer to Diagram 1)
20
919-967a
WOOD STOVES & INSERTS
Spacer
Washers
Diagram 1
Wood handle
2. Place the door onto the hinges and then place the door
handle through the opening on the door, as shown in
Diagram 2.
Re-assemble and secure the door handle components in
reverse order as removed in step 1, refer to Diagram 1.
3. Put the hinge cover caps on top of hinges to complete the
door installation.
Note: The bottom of the door may scrape the ashlip. In this
case place the spacers provided on the door hinges of
the unit before placing the door.
Door
Handle
4. Close door and ensure there is a tight seal. If door is too
tight, a washer can be added. If the door is not creating
a tight seal, a washer can be removed. Recheck door to
ensure there is still a tight seal. Repeat steps if door seal
is still not tight until a tight seal has been achieved. The
handle should be approximately in the 8 o'clock position
tooltip
when door is fully closed.(Diagram 3)
Door handle
tooltip
Door
Hinge Cap
Cover
Diagram 2
Diagram 3
F2500 Regency Freestanding Woodstove
Door hinges
04.03.19