Important: Read Before Use - Libelium Waspmote Plug & Sense! Series Technical Manual

2. Important: Read before use

The following list shows just some of the actions that produce the most common failures and warranty-voiding.
Complete documentation about usage can be found at http://www.libelium.com/development. Failure to comply
with the recommendations of use will entail the warranty cancellation.
Software:
Upload code only using Waspmote IDE. If a different IDE is used, Waspmote can be damaged and can become
•
unresponsive. This use is not covered under warranty.
Do not unplug any connector while uploading code. Waspmote can become unresponsive. This use is not
•
covered under warranty.
Do not connect or disconnect any connector while Waspmote is on. Waspmote can become unstable or
•
unresponsive, and internal parts can be damaged. This fact is not covered under warranty.
Hardware:
Do not handle black stickers seals on both sides of the enclosure ( Warranty stickers). Their integrity is the
•
proof that Waspmote Plug & Sense! has not been opened. If they have been handled, damaged or broken, the
warranty is void.
Do not open Waspmote Plug & Sense! in any case. This will automatically make the warranty void.
•
Do not handle the four metallic screws of Waspmote Plug & Sense!. They ensure waterproof seal.
•
Do not submerge Waspmote Plug & Sense! in liquids.
•
Do not place nodes on places or equipment where it could be exposed to shocks and/or big vibrations.
•
Do not expose Waspmote Plug & Sense! to temperatures below -20 ºC or above 60 ºC.
•
Do not power Waspmote with other power sources than the original provided by Libelium. Voltage and current
•
maximum ratings can be exceeded, stopping Waspmote working and voiding warranty.
Do not try to extract, screw, break or move Waspmote Plug & Sense! connectors far from necessary usage,
•
waterproof sealing can be damaged and warranty will be voided.
For more information:
•
Do not connect any sensor on the solar panel connector and also do not connect the solar panel to any of
•
sensor connectors. Waspmote can be damaged and warranty void.
Do not connect any sensor not provided by Libelium.
•
Do not place Waspmote Plug & Sense! where water can reach internal parts of sensors.
•
Do not get the magnet close to a metal object. The magnet is really powerful and will get stuck.
•
Do not place the magnet close to electronic devices, like PCs, batteries, etc, they could be damaged, or
•
information could be deleted.
http://www.libelium.com
-7-
Important: Read before use
v8.6