Page 1
OPERATION AND PARTS MANUAL MODEL MC12PH CONCRETE MIXER (HONDA GX340UT2QA2/GX340UT2QAP2 GASOLINE ENGINES) Revision #1 (09/02/15) www.discount-equipment.com THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Page 2
One of our experienced staff members will get back to you with a quote for the right part that your machine needs. We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mayco, Toro/Stone, Diamond Products, Magnum, Airman, Mustang, Power Blanket, Nifty Lift, Atlas Copco,...
Rotating parts hazards CAUTION Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE INJURY. NOTICE Addresses practices not related to personal injury. PAGE 6 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
ALWAYS check the equipment for loosened threads or bolts before starting. DO NOT use the equipment for any purpose other than its intended purposes or applications. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 7...
Page 9
NEVER tamper with the factory settings of the engine or engine governor. Damage to the engine or equipment can result if operating in speed ranges above the maximum allowable. PAGE 8 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Page 10
AC receptacle. the engine start diffi cult. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 9...
Page 11
Raise and lock mixer wheel stand in up position when towing. Place chock blocks underneath wheel to prevent rolling while parked. PAGE 10 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Page 12
The label must remain with the engine for its entire life. If a replacement emission label is needed, please contact your authorized engine distributor. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 11...
16.0 x 18.1 X 17.6 in. Dimension (L x W x H) (406 X 460 X 448 mm) Dry Net Weight 69.9 lbs (31.7 Kg.) MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 13...
For basic engine maintenance, refer to the engine maintenance section in this manual. For more detailed engine maintenance, refer to the Honda Engine Owner's manual furnished with the engine. PAGE 14 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
6. Tow Bar — This mixer uses various towing bars, please reference the frame assembly drawing and parts list in this manual to determine which tow bar meets your requirements. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 15...
OFF position stops engine operation. 5. Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture. PAGE 16 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
When towing of the mixer is required, place the drum in 5 when securing either tow bar to the towing vehicle. the up position (mouth facing upwards). MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 17...
Bend hips and knees to squat down to your load, keep it close to your body, and straighten your legs to lift. Figure A. Tow Bar and Safety Chain Installation PAGE 18 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
4. If the oil level is low (Figure 5), fill to the edge of the oil filler hole with the recommended oil type (Table 5). Maximum oil capacity is 2.33 pints (1.09 liters). MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 19...
Page 21
(Figure 7), which should be tested every time the unit is started. PULL OUT TO START ENGINE START/STOP SWITCH PUSH IN TO STOP ENGINE Figure 7. Start/Stop Switch PAGE 20 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
2. To start a cold engine, move the choke lever (Figure 9) to the CLOSED position. Figure 12. Engine Start/Stop Button Figure 9. Choke Lever MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 21...
Once the drum is at the desired position, pull down on the dump latch to lock the drum in position. Figure 15. Filling Mix Drum Figure 14. Mixing Drum Positioning PAGE 22 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Figure 17. Start/Stop Button (Stop Position) 2. Place fuel shut-off lever in the OFF position. 3. Clean drum of all debris and foreign matter. Figure 16. Filling Mixing Drum MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 23...
(2) These items should be serviced by your service dealer, unless you have the proper tools and are mechanically proficient. Refer to the HONDA Shop Manual for service procedures. (3) For commercial use, log hours of operation to determine proper maintenance intervals. PAGE 24 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Table 5. For engine oil capacity, see Table 3 (Engine Specifications). DO NOT overfill. 4. Install drain bolt with sealing washer and tighten securely. Figure 20. Engine Air Cleaner MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 25...
Page 27
1. For thorough mix and longer drum life, always wash drum out after each use. 2. NEVER! pour or spray water over the engine or electric motor. PAGE 26 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Failure to comply may result in serious injury. Table 7 (Tire Wear Troubleshooting) will help pinpoint the causes and solutions of tire wear problems. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 27...
Page 30
Place the mixing drum in the down position (mouth facing downward). Cover the mixer and place it a clean dry area, that is protected from harsh elements. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 29...
Fuel filter/lines clogged? Replace fuel filter. Fuel tank cap breather hole clogged? Clean or replace fuel tank cap. Air in fuel line? Bleed fuel line. PAGE 30 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Page 32
Check cable connections. Charge or replace Will not start, no power with key "ON". (if Battery disconnected or discharged? applicable) battery Ignition switch/wiring defective? Replace ignition switch. Check wiring. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 31...
Multiquip. Other entries will for sale through Multiquip. be clarified in the “Remarks” Column. PAGE 32 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
4....EM903113 ....BEARING CONE 2....3469 ......DUST CAP, AXLE NOTICE Part numbers on this Suggested Spare Parts list may supersede/replace the part numbers shown in the following parts lists. MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 33...
2. Use manufacturer’s recommended tire pressure values when inflating tires. DO NOT exceed recommended tire pressure. P/N 521232 NOTE: SAME POSITION ON OPPOSITE SIDE OF CABINET. PAGE 34 — MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15)
Page 36
DECAL, POWDER COATED NAMEPLATE .............1....CONTACT MQ PARTS DEPT. 491757 POP RIVET 521228 DECAL, DANGER NO SMOKING 948630 DECAL, PUSH TO STOP 518524 DECAL, ISO 9001:2000, EXPORT MC12PH CONCRETE MIXER • OPERATION AND PARTS MANUAL — REV. #1 (09/02/15) — PAGE 35...
One of our experienced staff members will get back to you with a quote for the right part that your machine needs. We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mayco, Toro/Stone, Diamond Products, Magnum, Airman, Mustang, Power Blanket, Nifty Lift, Atlas Copco,...