Table of Contents
Advertisement
1300:
Command ID
p:
0-255, number of samples of the Basic Sampling Period.
p=0 disables Basic Logging.
Scope: LP-MCU
Example:
1300,4 instructs the unit to log every fourth sample. If the sampling Period is every
15 minutes then one sample per hour will be logged.
4.4.6 Alternate Logging Rate
The parameter defines the Temperature and Counter Alternate Logging Rate.
1340,p
1340:
Command ID
p:
0-255, number of samples according to the Alternate Sampling Period.
p=0 disables Alternate Logging.
Scope: LP-MCU
4.4.7 Basic Sending Rate
The parameter defines the Basic Data Transmission Rate.
parameter affects the Battery Life.
1310,p
1310:
Command ID
p:
0-255, Logs according to the Basic Logging Rate.
Scope: LP-MCU, COMM_MCU
Example:
1300,4 instructs the unit to log every fourth sample. If the Sampling Period is 15
minutes, then one sample per hour will be logged.
1310,6 instructs the unit to arrange a Data transmission every 6 logs, which means
every 6 hours.
4.4.8 Alternate Sending Rate
The parameter defines the Alternate Data Transmission Rate.
parameter affects the Battery Life.
1345,p
1345:
Command ID
p:
0-255, Logs according to the Alternate Logging Rate.
Scope: LP-MCU, COMM_MCU
4.4.9 Standby Mode
A low power Standby Mode can be enabled or disabled by a special command. If
Standby mode is enabled, Temperature Sampling according to the Basic Sampling
Period are disabled. The system enters a low power mode and waits for a trigger
event from a Digital Input or the Counter for activating the Alternate Rate Set and
resume with Logging and Data Transfer.
1350,s
1350:
Command ID
s:
0/1, 1 Enable, 0 Disable
Scope: LP-MCU, COMM_MCU
BSC-50D User Guide
The value of this
The value of this
12
Advertisement
Table of Contents
