Indication Of Danger; Security In The Workplace - UTIFORM Delta-Mini Instructions Manual

Mini Pump
4.1.2

Indication of danger

Actions that require particular care and precaution to be taken have been marked with this
symbol:
This symbol is used to indicate all those jobs in which there may be danger
to the health of personnel if the parts are handled incorrectly. Please pay close
attention to the instructions and work with extra care. You should also follow the
general indications on security and for the prevention of accidents with reference to
the building sector.
This symbol is used to indicate all those procedures where it is obligatory to
have first read the user manual. An example of one of these procedures is when it is
necessary to uncouple parts of the machine. In this case there is the risk that the
material is still under residual pressure and it could splash your eyes, so it would be
necessary to wear protective glasses.
This symbol is used to indicate all those tasks in the user manual that could cause
damage to objects.
4.1.3
accordance with the technical rules on electricity.
The connection to the mains must always be protected by means of a protector switch
in case there is a fault in the current (current transformer for building sites).
Before correcting faults or carrying out maintenance or cleaning the machine, make
sure it is turned off at the mains switch. Unplug the machine from the mains and for
greater security hold the mains switch in place with a padlock.
Special attention must be paid to the following points:
- The protective grid on the material deposit must be screwed tightly shut!
- The mixing tube, the motor cover and feeder motor must be securely attached
to the machine!
All work carried out using the material pumping machine (for mortar or plaster)
should be in accordance with the general regulations on safety and accident
prevention in the building industry.
WARNING!

Security in the workplace

The machine must be checked for visible damage before each use.
Particular attention should be made to the electronic feeder cables,
plugs, couplings and pipes.
Work to the electric panel of the machine should only be carried out
by specialised technicians or by an electrical expert, and always in
WARNING!
8