Ferroli TITANO SMART 50 Installation, User And Maintenance Instructions page 10

If the appliance is not supplied with a power cable
Starting and testing
B Fig. 3
18
8
7. OPERATING INSTRUCTIONS
Pay careful attention to the general warnings and safety requirements described at the beginning of the document, strictly observing the
instructions given.
Tips for users
and the elderly are most susceptible to the risk of burns
9
8. TROUBLESHOOTING
Problem
Check:
-
Cold water comes out
-
-
Boiling water comes out (steam is released from the taps) Disconnect power to the appliance and check:
-
Check:
-
-
Insufficient hot water delivery
-
-
-
Check:
-
The indicator light doesn't come on
-
-
Leaky water connections Check:
-
Check:
-
Water leaks from the electrical assembly
-
Water dripping from the pressure relief device is normal when the water is being heated. To prevent dripping, install a
suitable expansion vessel on the outlet. If the dripping continues when water is not being heated, check:
Water leaks from the pressure relief device
-
-
If the water inside the heater is cold, dripping may occur. Always check for leaks when the water is at operating
Condensate, dripping
temperature.
NEVER ATTEMPT TO REPAIR THE APPLIANCE, ALWAYS CONTACT QUALIFIED TECHNICAL PERSONNEL.
appropriate without providing prior notice of such changes.
Children, disabled people
A Fig. 7
Solution
voltage at the terminal block;
the heating elements;
that the thermostat has been fitted correctly.
scale in the water heater and on the components.
the thermostat temperature setting;
mains water pressure;
the condition of the strainer on the cold water inlet pipe;
the condition of the hot water delivery pipe;
the electrical components.
that the indicator light is connected to the special socket ;
that the thermostat is not set to the minimum;
that the indicator light is not faulty.
that the connections are suitably sealed.
for water heaters with screw attachment, that the threaded connections are tight (if necessary, tighten
slightly);
for water heaters with flanges, that the bolts on the flange are tight (if necessary tighten slightly in a criss-
cross sequence) and the gasket is intact.
calibration of the pressure relief device;
mains water pressure.
WARNING! Never plug the drain hole on the pressure relief device!
19