Operating Modes - Timberk AC TIM 07C P6 Instruction Manual

7. OPERATING MODES

CONTROL PANEL & DESCRIPTION OF FUNCTION
3
2
1. Power button. Press this button to switch on or off the unit
2. Light of high cooling. The appliance will work in cooling mode with
high fan speed.
3. Light of low cooling. The appliance will work in cooling mode with
low fan speed.
4. Light of alarm
5. Light of low fan speed. The appliance will work in low fan speed.
6. Light of high fan speed. The appliance will work in high fan speed.
6
www.timberk.com • Electric air conditioner
4
5
6
1
NOTICE:
Never turn the air conditioner off by unplugging
from the mains. Always press the button 1,
then wait for a few minutes before unplugging.
This allows the appliance to perform a cycle of
checks to verify operation.
ATTENTION!
The unit can evaporate condensed water and
automatically drain it through the hose*.
When the unit is in cooling mode, it is not necessary
to install the condensate drainage pipe since
condensate evaporates automatically. Make sure
that when the unit is operating, the rubber plug of
the drainage hose is securely fixed.
Disconnect the air outlet hose, connect the
drainage hose to the drainage hole and drain water
from the unit to ensure maximum dehumidification
efficiency.
When drain hose not attached water collects in the
tank for condensate. When the tank is filled on the
LCD display shows the E4.
To resume the operation, remove the rubber plug of
the drainage hose to drain water at first. After water
is drained...