Sensors & Software LMX100 User Manual page 27

•
Press Username to display a keyboard where you can enter your GMAIL user name
only; you do not need to enter @gmail.com. Then press OK when done (Figure 4-6a)
•
Press Password to display a keyboard where you can enter your GMAIL password.
Then press OK when done (Figure 4-6b)
•
Press Save when both Username and Password have been entered.
If there are no warning messages, the email address is setup properly and you are ready to
email mini-reports from the field. If this does not work, see the
Using Another Provider
Note: It is highly recommended to use a GMAIL account as the system is pre-configured
for this. If you choose to use another provider, you will have to contact that provider if
you have any issues with the settings.
To use another email provider, press the + and – buttons under Provider until it says Custom.
This will display the screen shown in Figure 4-7 allowing you to setup and configure a different
email provider:
Figure 4-6: Entering email address (a) and password (b) for GMAIL
Failed Setup
15
Tools
section below